Cerwin-Vega Cerwin Vega CVM-1022 Owner's Manual

10 

 

 
(7). SEND JACKS 
* AUX: These are unbalanced phone jacks-type output jack. This jack output the signal form AUX bus, respectively. You 
use this jack, for example, to connect to an effector or to a cue box or other such monitoring system.   
* EFX: These are unbalanced phone jacks-type output jack that output the signal form the EFFECT bus. You use this jack, 
for example, to connect to an external effector   
 
(8). RETURN L (MONO), R Jack   
These are unbalanced 1/4” phone-type line input jacks. The signal received by these jacks is sent to the MAIN bus and 
AUX bus. These jacks are typically used to receive a return signal from an external effect (reverb, delay, etc.)   
 

NOTE: These jacks can also be used as an auxiliary stereo input. If you connect to the L (MONO) jack only, the mixer 
will recognize the signal as monaural and will propagate the identical signal on both L and R jacks   

(9). MAIN L/R OUTPUT JACKS   
These jacks deliver stereo output of the mixer signal. You use these jacks, for example, to connect to the power 
amplifiers driving your main speakers. You also use these jacks when you wish to record the signal utilizing the level 
control applied by the main volume in the main Control section.   

(10). CONTROL ROOM OUTPUT JACKS   
Use these stereo phone-type output jacks to connect to your monitor system.   

NOTE: The main output signals also route to these jacks controlled by the CTRL ROOM / PHONES volume.   

(11). HEADPHONE JACK   
Connect for headphones. This is stereo phone-type output jack (3-conductor TRS).   

 

 

NOTE: The main output signals also route to these jacks controlled by the CTRL ROOM / PHONES volume.