Sony DXS-M5511BT Marine Package Owner's Manual

libFLAC

Redistribution and use in source and binary forms,
with or without modification, are permitted
provided that the following conditions are met:

 Redistributions of source code must retain the

above copyright notice, this list of conditions and
the following disclaimer.

 Redistributions in binary form must reproduce

the above copyright notice, this list of conditions
and the following disclaimer in the
documentation and/or other materials provided
with the distribution.

 Neither the name of the Xiph.org Foundation nor

the names of its contributors may be used to
endorse or promote products derived from this
software without specific prior written
permission.

THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT
HOLDERS AND CONTRIBUTORS “AS IS” AND ANY
EXPRESS OR IMPLIED WARRANTIES, INCLUDING,
BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE ARE DISCLAIMED. IN NO
EVENT SHALL THE FOUNDATION OR CONTRIBUTORS
BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
DAMAGES (INCLUDING, BUT NOT LIMITED TO,
PROCUREMENT OF SUBSTITUTE GOODS OR
SERVICES; LOSS OF USE, DATA, OR PROFITS; OR
BUSINESS INTERRUPTION) HOWEVER CAUSED AND
ON ANY THEORY OF LIABILITY, WHETHER IN
CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING
NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
OUT OF THE USE OF THIS SOFTWARE, EVEN IF
ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.

Troubleshooting

The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check
the connection and operating procedures.
For details on using the fuse and removing the unit
from the dashboard, see “Connection/Installation”
(page 33).
If the problem is not solved, visit the support site on
the back cover.

General

No power is being supplied to the unit.
 If the unit is turned off and the display

disappears, the unit cannot be operated with the
remote commander.
 Turn on the unit.

No sound or the sound is very low.
 The position of the fader control [FADER] is not

set for a 2-speaker system.

 The volume of the unit and/or connected device

is very low.
 Increase the volume of the unit and connected

device.

No beep sound.
 An optional power amplifier is connected and

you are not using the built-in amplifier.

The contents of the memory have been erased.
 The power supply lead or battery has been

disconnected or not connected properly.

Stored stations and correct time are erased.
The fuse has blown.
Makes a noise when the position of the ignition
is switched.
 The leads are not matched correctly with the

boat’s accessory power connector.

During playback or reception, the demonstration
mode starts.
 If no operation is performed for 5 minutes with

[DEMO-ON] set, the demonstration mode starts.
 Set [DEMO-OFF] (page 21).