K&M Single Speaker Stand Owner's Manual

- Max. central capacity: 50 kg
- Before and after use check stand for damage.

-

Damaged Stands may not be used.

- The stand must not be loaded unevenly. 
- The ground must be even and suitable for a stand.
- 2 technicians are needed to set up the stand

-

(physical strength required).

- Before installing the stand check that the tripod, loud

-

speakers and other devices (cables) function correctly.

- Check that the loud speakers are suitable, i.e. that

-

the flange bushing is the correct size and type.

- Do not allow unauthorised persons near the stand

-

when weighted: make sure there is no danger of

-

tripping and that the stand cannot tip.

- Check the stand is safe: 

-

- are the screws tight?

-

- The stand is most stable when the leg struts are

- -

horizontal and level.

-

- Be especially careful when removing the locking

- -

pin and clamping screw from the telescopic section.

- WARNING: Moving the stand when weighted could

-

damage the leg sections.

- When adjusting the stand take care: potential 

-

pinching hazard.

Thank you for choosing this product. These instructions describe the procedure for properly assembling and adjusting the stand. 
We recommend keeping the instructions as you may need them at a later date.

KÖNIG & MEYER GmbH & Co. KG 

Kiesweg 2, 97877 Wertheim, www.k-m.de

21435-009-55  Rev.11  03-79-171-00  5/15

Materials

- base, leg: steel
- telescopic sections, struts and locking pins: steel
- shaft collar: polyamide (PA)
- end caps, shock absorber: (TPE)

Load capacity

- max. 50 kg central load

Dimensions

- max. base spread ø 1150 mm
- height: 1440-2230 mm (for max. base)
- telescopic section: ø 35 mm

Packed dimensions, kg

W x D x H: 122 x 141 x 1183 mm, 5.5 kg

Delivery box, kg

W x D x H: 130 x 120 x 1185 mm, 6.2 kg

Accessories (optional)

- carrying case 21311 (for one or two 21435)
- K&M flange adapter (e.g. 19580, 19654, 19656, etc.) 
- scrow-on adapter (24281)
- adapter sleeve 21326: ø 38 mm (= US variation)

It is easy to set-up the 21435 speaker stand. All parts
are ready to use, the stand only needs to be positioned.

(1) Slightly loosen the clamping screw on the tripod
shaft sleeve. 
(2) Straddle the legs until...
(3) ...the strut sections are horizontal.
(4) Re-tighten the clamping screw.

(4) 

NOTE: 

(4) 

Normal hand strength is sufficient; please avoid

(4) 

over-tightening the screw as this will strain the 

(4) 

stand sections.