TiVo Bolt® V2 Owner's Manual

Page of 111
81
A
A
FCC STATEMENT TO THE USER
Relevant safety and compliance information can be found at 
tivo.com/safety-compliance
This equipment has been tested and found to comply with the 
limits for a Class B digital device, pursuant to Part 15 of the FCC 
Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential 
installation. This equipment generates, uses and can radiate 
radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference 
to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this 
equipment does cause harmful interference to radio or television 
reception, which can be determined by turning the equipment 
off and on, the user is encouraged to try to correct the 
interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different 
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for 
help.
FCC Caution: Any changes or modifications not expressly 
approved by the party responsible for compliance could void the 
user’s authority to operate this equipment. 
This device complies with Part 15 of the FCC Rules. Operation is 
subject to the following two conditions: (1) This device may not 
cause harmful interference, and (2) this device must accept any 
interference received, including interference that may cause 
undesired operation.
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set 
forth for an uncontrolled environment. End users must follow the 
specific operating instructions for satisfying RF exposure 
compliance. To maintain compliance with FCC RF exposure 
compliance requirements, please follow operation instructions as 
documented in this manual.
This transmitter must not be co-located or operating in 
conjunction with any other antenna or transmitter. This 
equipment should be installed and operated with a minimum 
distance of 20 cm between the radiator and your body.
The availability of some specific channels and/or operational 
frequency bands are country dependent and are firmware 
programmed at the factory to match the intended destination. 
The firmware setting is not accessible by the end user.
COMPLIANCE INFORMATION
Model numbers: TCD849500 (500GB), TCD849000 (1TB), 
RC30A00, RC30B00 (Remote) 
FCC IDs: TGN-TCD8495 (TiVo BOLT), TGN-RC30 (Remote), 
RAXWN8722BTAAC (Wi-Fi board)
TiVo Inc. 2160 Gold Street, San Jose, CA 95002