Sony STRDH130 Owner's Manual

D:\NORM'S JOB\SONY HA\SO0173\STR-DH130\4294472111_GB\GB06REM_STR-DH130-
U2.fm

STR-DH130

4-294-472-11(1)

• Point the remote control at the remote 

control sensor on the receiver.

• Remove any obstacles in the path between 

the remote control and the receiver.

• Replace all the batteries in the remote 

control with new ones, if they are weak.

• Make sure you select the correct input on 

the remote control.

If there is a malfunction, a message appears on 
the display panel. You can check the condition 
of the system by the message. If any problem 
persists, consult your nearest Sony dealer. 

Irregular current is output to the speakers, or 
the receiver is covered and ventilation holes 
are blocked. The receiver will automatically 
turn off after a few seconds. Check the 
speaker connection and turn on the power 
again.

With 8 ohm loads, both channels driven, from 
20 – 20,000 Hz; rated 90 watts per channel 
minimum RMS power, with no more than 
0.09% total harmonic distortion from 250 
milliwatts to rated output.

Amplifier section
USA, Canada and Europe models

1)

Minimum RMS Output Power (8 ohms, 20 Hz – 
20 kHz, THD 0.09%) 

90 W + 90 W

Stereo Mode Output Power

 

(8 ohms, 1 kHz,

 

THD 1%) 

100 W + 100 W

1)

Measured under the following conditions:

Frequency response

Analog

10 Hz – 70 kHz

 

+0.5/–2 dB (with BASS = 
0 dB, TREBLE = 0 dB)

Input

Analog (PORTABLE IN)

 

Sensitivity: 1 V/
50 kilohms

 

S/N

2)

: 96 dB (A, 500 mV

3)

)

Inputs

Analog (Except PORTABLE IN)

 

Sensitivity: 500 mV/
50 kilohms

 

S/N

2)

: 96 dB (A, 500 mV

3)

)

Outputs

Analog (AUDIO OUT)

 

Voltage: 500 mV/
10 kilohms

All memorized settings

USA, Canada

120 V AC, 60 Hz

Europe

230 V AC, 50 Hz