NAD C 368 Owner's Manual

23. Battery Disposal - When disposing of used batteries, please comply with 

governmental regulations or environmental public instruction’s rules that apply in 

your country or area.

24. Safety Check - Upon completion of any service or repairs to this product, ask the 

service technician to perform safety checks to determine that the product is in 

proper operating condition. 

25.  Wall or Ceiling Mounting - The product should be mounted to a wall or ceiling 

only as recommended by the manufacturer.

The lightning flash with arrowhead symbol, within an equilateral 

triangle, is intended to alert the user to the presence of uninsulated 

“dangerous voltage” within the product’s enclosure that may be of 

sufficient magnitude to constitute a risk of electric shock to persons

The exclamation point within an equilateral triangle is intended to alert 

the user to the presence of important operating and maintenance 

(servicing) instructions in the literature accompanying the appliance.

THE EQUIPMENT MUST BE CONNECTED TO AN EARTHED MAINS SOCKET-OUTLET.

To maintain proper ventilation, be sure to leave a space around the unit (from the 

largest outer dimensions including projections) than is equal to, or greater than 

shown below. 

Left and Right Panels: 10 cm 

Rear Panel: 10 cm 

Top Panel: 10 cm 

This equipment has been tested and found to comply with the limits for Class 

B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed 

to provide reasonable protection against harmful interference in a residential 

installation. This equipment generates, uses, and can radiate radio frequency 

energy and, if not installed and used in accordance with the instructions, may cause 

harmful interference to radio communications. However, there is no guarantee that 

interference will not occur in a particular installation. If this equipment does cause 

harmful interference to radio or television reception, which can be determined 

by turning the equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which 

the receiver is connected.

Consult the dealer or an experienced radio TV technician for help.

Changes or modifications to this equipment not expressly approved by NAD 

Electronics for compliance could void the user’s authority to operate this 

equipment.

This device complies with Part 15 of the FCC Rules / Industry Canada licence-

exempt RSS standard(s). Operation is subject to the following two conditions: 

1  This device may not cause harmful interference, and 
2  This device must accept any interference received, including interference that 

may cause undesired operation.

Under Industry Canada regulations, this radio transmitter may only operate 

using an antenna of a type and maximum (or lesser) gain approved for the 

transmitter by Industry Canada. To reduce potential radio interference to other 

users, the antenna type and its gain should be so chosen that the equivalent 

isotropically radiated power (e.i.r.p.) is not more than that necessary for successful 

communication.

To prevent electric shock, match wide blade of plug to wide slot, fully insert.

Marking and rating plate can be found at the rear panel of the apparatus.

To reduce the risk of fire or electric shock, do not expose this apparatus to rain or 

moisture. The apparatus shall not be exposed to dripping or splashing and that 

no objects filled with liquids, such as vases, shall be placed on apparatus. 

Mains plug is used as disconnect device and it should remain readily operable 

during intended use. In order to disconnect the apparatus from the mains 

completely, the mains plug should be disconnected from the mains socket outlet 

completely. 

Battery shall not be exposed to excessive heat such as sunshine, fire or the like.

Danger of explosion if battery is incorrectly replaced. Replace only with the same 

or equivalent type.

An appliance with a protective earth terminal should be connected to a mains 

outlet with a protective earth connection.

To satisfy FCC/IC RF exposure requirements, a separation distance of 20 cm or more 

should be maintained between the antenna of this device and persons during 

device operation. To ensure compliance, operations at closer than this distance is not 

recommended. 

This product is manufactured to comply with the radio interference 

requirements of EEC DIRECTIVE 2004/108/EC.

At the end of its useful life, this product must not be disposed of with 

regular household waste but must be returned to a collection point for 

the recycling of electrical and electronic equipment. The symbol on the 

product, user’s manual and packaging point this out. 

The materials can be reused in accordance with their markings. 

Through re-use, recycling of raw materials, or other forms of recycling of old products, 

you are making an important contribution to the protection of our environment. 

Your local administrative office can advise you of the responsible waste disposal point. 

The model and serial number of your new C 368 are located on the back of the 

cabinet. For your future convenience, we suggest that you record these numbers here: 

 

Model number :   . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

 

Serial number : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

 

 

NAD is a trademark of NAD Electronics International, a division of Lenbrook Industries Limited

Copyright 2017, NAD Electronics International, a division of Lenbrook Industries Limited