Russound CAA66 Owner's Manual

29

SRC1 Remote Control
is aimed at IR In on
CAA66 during setup 

Zone Indicator LEDs repre-
sent source and controller
ID numbers 1 to 6 
(left to right)

Indicator LEDs turn on/off and blink slow/fast to indicate
setup process steps and to indicate when to enter infor-
mation via the SRC1 

1         2         3          4         5          6

The CAA66 and its connected sources are configured
through the Programming Center, located on the front
of the CAA66 behind the removable lower panel. The
LEDs are dual purpose with different colors to indicate
different modes. 

The CAA66 has two main programming modes:
Controller Setup Mode and Source Setup Mode.
The bottom row of functions are used in Controller
Setup Mode (Ctrl ID, Num Src and Fact Init) and are
accessed with a press and hold of the Setup button.
The top row of functions are used in Source Setup
Mode (Source/Test, Cmd/Type, Code/Key and 

IR/Learn) and are accessed with a press of the Setup
button.
The SRC1 system remote control is used to enter
information during the setup procedures, and the LEDs
show solid, blinking or off to indicate what is being
programmed and when to enter information. The six
zone LEDS on the front of the controller are used to
represent the numbers 1 through 6 during Controller
setup and sources 1 through 6 during Source setup.
To exit either setup mode, press the Setup button until
no LEDs are illuminated in the Programming Center.