Russound CAA66 Controller Kit Owner's Manual
17
INSTALLER
COMPONENT GUIDE
Keypad Update Port
1
The KPSC 12-pin header and the update jumper for the KP6 (and KPL) are located on the right side
of the keypad when facing front. These are covered when a trim plate is installed.
Note: The update pins on the KP6 are accessed from the side when the keypad is not installed.
of the keypad when facing front. These are covered when a trim plate is installed.
Note: The update pins on the KP6 are accessed from the side when the keypad is not installed.
2
OS UPDATE/RUN JUMPER -The pins are
jumpered when performing a firmware
update on the keypad. The jumper is
removed during normal operation.
jumpered when performing a firmware
update on the keypad. The jumper is
removed during normal operation.
KPSC PORT - 12-pin header for connec-
tion to KPSC source control keypad.
tion to KPSC source control keypad.
OS UPDATE PORT - Used to update the
KP6 and KPL keypad operating system
firmware. If an update is released, it will
be available online through the
Document Center on
www.russound.com. Look in the
“Firmware and Downloads” section under
Multi-Zone product type. The Advanced
Programming Cable is available from
Russound, Part #2500-521065.
KP6 and KPL keypad operating system
firmware. If an update is released, it will
be available online through the
Document Center on
www.russound.com. Look in the
“Firmware and Downloads” section under
Multi-Zone product type. The Advanced
Programming Cable is available from
Russound, Part #2500-521065.
1
2
KP6 Front View
3
3
KP6 Top View
3
KP6 Side View
1
Jumpered
pins
pins