Acoustic Landscape Acoustic Landscape™ AS4.1 Owner's Manual
5
WWW.ACOUSTIC-LANDSCAPE.COM
AS41HI-FI LANDSCAPE AUDIO SYSTEM MANUAL
Installation
Lay out the speakers and subwoofer in their selected locations.
To prevent water damage, angle the speaker less than 45 degrees
up.
To prevent water damage, angle the speaker less than 45 degrees
up.
Dig a hole for the subwoofer, about 16” deep and 11” in diameter.
Use loose dirt to level the subwoofer. The subwoofer shouldn’t be
in contact with large rocks or large empty holes.
Use loose dirt to level the subwoofer. The subwoofer shouldn’t be
in contact with large rocks or large empty holes.
You will need a wire that has at least two conductors; one that can be
identified as the positive and the other as the negative. All two conductor
wires have some means of identifying which conductor is which, but at
times this identification may be subtle. It’s crucial that you keep track
of which wire you use for positive (+) and negative (-). Typically if the
wires are colored red and black, the red wire is used for positive and the
black wire is used for negative. You can choose whichever color of wire
you want to be positive and negative as long as you remain consistent
throughout the install.
identified as the positive and the other as the negative. All two conductor
wires have some means of identifying which conductor is which, but at
times this identification may be subtle. It’s crucial that you keep track
of which wire you use for positive (+) and negative (-). Typically if the
wires are colored red and black, the red wire is used for positive and the
black wire is used for negative. You can choose whichever color of wire
you want to be positive and negative as long as you remain consistent
throughout the install.
Your amplifier, speakers and subwoofer will use red for positive and black
for negative. It is very important to be certain that the same wire that
is attached to the positive connector in the amplifier is attached to the
positive connector at the speaker.
for negative. It is very important to be certain that the same wire that
is attached to the positive connector in the amplifier is attached to the
positive connector at the speaker.
About Speaker Wire
Dig a 5” trench where you plan on laying out the wire. Run the
wire from the amplifier to your first speaker location.
wire from the amplifier to your first speaker location.