Revel Performa3 F208 Owner's Manual
9
Revel Performa3 F208/F206 Floorstanding Loudspeaker
Owner’s Manual
F208 Vertical Bi-Amped Connections
CAUTION: Remove the shorting straps before making bi-
amped connections. Failure to do so may cause damage to
some power amplifi ers.
amped connections. Failure to do so may cause damage to
some power amplifi ers.
Vertical bi-amped connections are made between both pairs of F208
input terminals and two separate output channels of a single power
amplifi er. Each F208 loudspeaker is connected to an individual power
amplifi er, which can sometimes increase sonic performance. The power
amplifi ers for the two loudspeakers must be identical.
input terminals and two separate output channels of a single power
amplifi er. Each F208 loudspeaker is connected to an individual power
amplifi er, which can sometimes increase sonic performance. The power
amplifi ers for the two loudspeakers must be identical.
NOTE:
s
power amplifi ers, one for each loudspeaker.
s
amplifi er channels must receive identical input signals from the
associated preamplifi er. If the associated preamplifi er does not
have two output connectors for each channel, “Y” adaptors are
required.
associated preamplifi er. If the associated preamplifi er does not
have two output connectors for each channel, “Y” adaptors are
required.
1. Remove the shorting straps.
2. Connect one speaker cable to the high-frequency set of F208 input
terminals. Then connect the other end of that speaker cable to the
desired power amplifi er output channel.
desired power amplifi er output channel.
3. Connect another speaker cable to the low-frequency set of F208
input terminals. Then connect the other end of that speaker
cable to another output channel of the same power amplifi er you
connected to the high-frequency input terminals.
cable to another output channel of the same power amplifi er you
connected to the high-frequency input terminals.
4. Connect both amplifi er channel inputs to the output of a single
preamplifi er channel. If the preamp only has one connector for the
channel, use a “Y”-adaptor.
channel, use a “Y”-adaptor.
5. Repeat steps 1, 2 and 3 to connect the second F208 to another,
identical power amplifi er. Repeat step 4 to connect the second
amplifi er to the preamplifi er’s other channel.
amplifi er to the preamplifi er’s other channel.
OUTPUT A
OUTPUT A
OUTPUT B
INPUT A
INPUT B
Preamp
(one channel shown)
(one channel shown)
Y-Adapter for
Single Connector
Single Connector
F208
Connector
Panel
Connector
Panel
Shorting
Straps
Removed
Straps
Removed
Two-Channel
Amplifi er*
Amplifi er*
* Amplifi er for other loudspeaker
must be identical