Petsafe 100 Yard Lite Remote Trainer Owner's Manual
petsafe.com | Customer Care Center +1 (800) 732-2677
5
Charge the Training Collar and Remote
Excessive charging can shorten battery life. Only charge your remote or collar when the batteries are low.
1. Plug in and fully charge the remote and training collar. This can take up to 5 hours.
2. When fully charged, the green LED on the collar will turn off, and the battery meter on the remote will stop cycling and
2. When fully charged, the green LED on the collar will turn off, and the battery meter on the remote will stop cycling and
appear full.
3. When the collar and remote are charged, replace their rubber covers.
To Turn the Training Collar On
Press and hold the on/off button until you hear a low to high beep and the green LED appears,
and then release.
and then release.
NOTE: The handheld remote is always on, and the display will appear when any button is pressed.
To Turn the Training Collar Off
Press and hold the on/off button until the collar beeps high to low, and then release. The red LED will
be illuminated during the button press and will turn off when the collar turns off.
be illuminated during the button press and will turn off when the collar turns off.
Quick Tip: When you’re not using the collar, you’ll want to turn it off to increase
the battery life. When storing for long periods, recharge every 4 to 6 weeks.
the battery life. When storing for long periods, recharge every 4 to 6 weeks.
Test the Remote Trainer
We recommend you experience firsthand how the static stimulation functions. Always begin at the lowest level, and increase the
intensity up to your personal comfort level.
intensity up to your personal comfort level.
1. Place one finger over both contact points of the training collar.
2. Hold your remote approximately 2 ft. from the training collar. Starting at level 0, press the vibration button continuously for 1
2. Hold your remote approximately 2 ft. from the training collar. Starting at level 0, press the vibration button continuously for 1
to 2 seconds. You should feel continuous vibration. There is one level of vibration.
3. Increase the level to 1 for static stimulation. At this level you may not feel the stimulation. NOTE: Continuous stimulation will
transmit for no more than 10 continuous seconds. To reactivate, release and repress the button.
4. Increase the level on the static level adjuster until the sensation begins to feel uncomfortable.
Tone Symbol: Delivers a tone with non-adjustable volume to the collar.
Vibration Symbol: Sends 1 non-adjustable level of vibration stimulation to
the collar. Level 0 is vibration.
the collar. Level 0 is vibration.
Static Symbol: Delivers up to 15 levels of static stimulation to the collar that can
be adjusted with the level adjuster button. Levels 1-15 are static stimulation.
be adjusted with the level adjuster button. Levels 1-15 are static stimulation.
Lock Symbol: Indicates static stimulation levels 8-15 are locked.
Dog 1/2: Indicates which training collar is active.
Battery Indicator: Indicates the amount of battery remaining in the remote.
On/Off
Button
Button
Charging
Port
Port
Level Adjuster
0=Vibration
1-15=Static
0=Vibration
1-15=Static
Tone
Vibration/
Static
Static
Dog 1
*
Dog 2
Dog 1/2 function is available on the 300 Yard
Remote Trainer and higher.
Remote Trainer and higher.
*