Oppo RMK-UDP205 Owner's Manual

Page of 1
Rack Mount Kit Installation Guide
Part Number: RMK-205 
Contents: (2) rack mount brackets, (2) rack mount spacers, and (4) side panel screws. 
Installation: 
1.  Remove the 4 screws from the UDP-205’s left 
and right panels. Save the screws for Step 3.   
2.  Position one bracket to the right side of the 
player, and align the top hole in the bracket with 
the hole in the player’s side panel, as shown in 
Figure 1. Secure the bracket to the player using 
the side panel screws supplied with the rack 
mount kit. Do not use the side panel screws 
removed from the player because those are 
too short. Install the other bracket to the left 
side similarly. 
3.  Position the shorter spacer over the top of the 
front panel of the player, as shown in Figure 2. 
Use two screws saved from Step 1 to secure the 
spacer at each end to the Left and Right 
brackets. Install the taller spacer under the front 
panel similarly. 
4.  The completed unit should look like Figure 3. It 
is ready to be mounted using the screws that 
came with your equipment rack. 
Caution:
The player needs to fit into a 3U rack space. It is 
recommended to leave a blank or ventilated 1U 
space below and above the player to allow for 
better cooling.   
The player should not be installed directly above a 
heat-generating device such as a power amplifier 
or A/V receiver.   
Please also check the rack manufacturer’s 
instructions and allow for enough ventilation 
(Bottom, Top and Sides). 
OPPO Digital Inc. 
    162 Constitution Dr. 
  Menlo Park, CA 94025, U.S.A. 
www.oppodigital.com 
Figure 1 
Figure 2 
Figure 3