Sony DT 35 mm f/ 1.8 SAM Lens Specification Guide

SAL35F14G (1.4/35G) (35mm F1.4G)

Adhesive bond (LOCTITE 460) (Note)

Use adhesive bond (LOCTITE 460) or an equivalent article.

Do not use what becomes white after drying like quick-drying glue.

Apply the adhesive bond (LOCTITE 460) to the tip of mount guide mark and install it to the G ornamental block.

Adhesive bond (LOCTITE 460) (Note)

Use adhesive bond (LOCTITE 460) or an equivalent article.

Do not use what becomes white after drying like quick-drying glue.

Adhesive bond (B-10): J-6082-612-A

1.

Apply a little amount of the adhesive bond (LOCTITE 460) to the indicated portions of focus hold button base.

2.

Apply the adhesive bond (B-10) to the tip of one screw shown in figure and tighten the screw.

3.

Perform “4-8. FOCUS HOLD BUTTON CHECK (FOCUS HOLD BUTTON)”.

ft

m

Mount guide mark

Apply the adhesive bond (LOCTITE 460)
to the tip mount guide mark

G Ornamental Block

Focus Hold Button Base

Click Plate

Dust Protection Tape

Focus Hold Button

Washer

Apply the adhesive bond (B-10) 

Apply the adhesive bond (LOCTITE 460)