Sensor Switch Inc. SSIINTR003 User Manual

900 Northrop Road, Wallingford, CT 06492     Phone: 1-800.PASSIVE     Fax: 203-269-9621     www.sensorswitch.com     ©2013 Acuity Brands Lighting, Inc.     All rights reserved 12/06/13

5 of 8

Wireless Sensor & Switch

Frequency that the sensor will transmit status 

information.

Step 1. Press and release button 3 times

Step 2. LED will flash back current setting

Step 3. To change setting, press button the number 

of increments of  the new setting from below list:

  1 - 30 sec           2 - 2.5 min         3 - 5.0 min*

Step 4. LED will flash back new setting (repeats 3 

times, then exits)

Temporarily sets heartbeat time to 5 sec and              

     

flashes LED whenever occupancy is detected. 

To Enter test mode:

Step 1. Press and release button 6 times

Step 2. Wait until LED begins to flash back 

Step 3. Press and release button twice

To Exit test mode:

Step 1. Press and release button 6 times

Step 2. Wait until LED begins to flash back 

Step 3. Press and release button once

Notes: 

1. Test mode expires automatically after 10 min

2. Paired SPODMR WR units will also enter and                  

              

exit Test Mode simultaneously with sensor

3. Dual Technology disabled while in Test Mode

Duration that the microphone will stay on after the last 

occupancy transmission.

Step 1. Press and release button 4 times

Step 2. LED will flash current setting

Step 3. To change setting, press button the number of 

increments of  the new setting from below list:

  1 - 45 sec  

4 - 7.75 min  

7 - 15.25 min

  2 - 2.75 min  5 

- 10.25 min*

  3 - 5.25 min   

6 - 12.75 min

Step 4. LED will flash back new setting (repeats 3 times, 

then exits)

Duration the microphone stays on without sensor ever 

detecting motion via PIR.

Step 1. Press and release button 5 times

Step 2. LED will flash current setting

Step 3. To change setting, press button the number of 

increments of  the new setting from below list:

  1 - 15 min   

3 - 45 min 

5 - Infinite

  2 - 30 min  4 - 1 hr*

 

Step 4. LED will flash back new setting (repeats 3 times, 

then exits)

Transmits sensor ID to facilitate pairing with other 

devices. 

Step 1. Press and release button 2 times

Step 2. LED will rapid flash when transmitting

Note: Sensor resumes normal operation after one 

transmission is sent

Returns unit to orignal factory settings.

Step 1. Press and release button 9 times

Step 2. LED will flash once

Step 3. Press and release button 2 times 

Step 4. LED will flash back twice (repeats 3 times, 

then exits and resets)

Use push-button on side of sensor to 

change settings.

       *  Denotes factory setting

       **Applies to Dual Technology (-PDT)

            sensors only

 

 

AA Lithium

AA Lithium