Magicard 3663-0001 User Manual
ReTransfer ID Card Printer – User Manual
67
the firmware, or a problem with the FPGA.
9000: ERR_HEATER_OVERTEMPERATURE
Error code 9000.0
Reason: In the firmware module which controls the heated roller temperature, the
printer detected that the heated roller temperature was above the maximum permitted
level. This is either due to a fault in the control software, or a problem with the temperature
measurement hardware.
Contact your printer supplier and press
"Cancel" to power printer off.
9001:
ERR_PRINTHEAD_OVERTEMPERATURE
Error code 9001.0
Reason: In the firmware module which controls the print head temperature, the printer
detected that the print head temperature was above the maximum permitted level. This is
either due to a fault in the control software, or a problem with the temperature
measurement hardware.
Contact your printer supplier and press
"Cancel" to power printer off.
9002:
ERR_HEATER_SENSOR_DISCONNECTED
Error code 9002.0
Reason: In the firmware module which controls the heated roller temperature, the
temperature sensor alarm was triggered and the temperatures sensor was reporting an
unusually low temperature. This is almost always because the temperature sensor is not
connected properly.
Contact your printer supplier and press
"Cancel" to power printer off.
9003: ERR_PRINTHEAD_DISCONNECTED
Error code 9003.0
Reason: In the firmware module which controls the print head temperature, the
temperature sensor was reporting an unusually low temperature. This is almost always
because the print head is not connected properly.
Contact your printer supplier and press
"Cancel" to power printer off.