Shenzhen Jehe Technology Development Co. Ltd. I30 User Manual

(2) If only connected CRT display device, the default display mode is the Intel (R)

Dual Display Clone mode, the best resolution if the display is greater than

1366X768, will not achieve the best resolution display devices, display devices

need to manually set the most good resolution

Steps: right click desktop -> click “screen resolution” -> Settings "resolution"

(3) If HDMI and CRT display devices were connected at the same time, the default

display mode is the Intel (R) Dual Display clone mode, the maximum resolution

can be up to 1366x768 (can also set other higher resolution, but the HDMI

display will be missed).

If the problem can't solved even after the above measures are taken, you may

contact our customer service center or log in the official forum of Giada.

Please prepare the materials listed below before you contact so as to receive

prompt service from us.

· True product name and model;

· Product code and its serial number;

· Date of purchase;

· Brief introduction of the problem on your PC;

· Information concerning the software and other external hardware.

www.giadatech.com

Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC RF radiation exposure limits set forth for an

uncontrolled environment. This device and its antenna must not be co-located or

operating in conjunction with any other antenna or transmitter.

“To comply with FCC RF exposure compliance requirements. The antennas used

for this transmitter must be installed to provide a separation distance of at least 20

cm from all persons and must not be co-located or operating in conjunction with

any other antenna or transmitter.”