Wireless Seismic Inc. 00401 User Manual
Draft
R03.d
RT 1000 v1.3 Deployment Guide
61
© 2010-2011 Wireless Seismic, Inc. All rights reserved.
Backhaul
Setting up the Backhaul Equipment
11 Attach a radio to the electronics carrier.
12 Uncoil an Ethernet cable, attach one end to a radio unit and the other end to
12 Uncoil an Ethernet cable, attach one end to a radio unit and the other end to
the PoE. Form a service loop (extra cable) by looping the Ethernet cable over
the top of the radio unit. If you are installing two radios on the mast, refer to
“Installing Two Radios on the Mast” on page 69 for cabling and configuration
instructions.
the top of the radio unit. If you are installing two radios on the mast, refer to
“Installing Two Radios on the Mast” on page 69 for cabling and configuration
instructions.
13 Ensure that all directional antennas, when raised, are pointed correctly. The
radio unit should be facing toward the recording truck.
14 Thread guy lines through the guy line collar on the electronics carrier and
thread through cleats on the bottom mast tube.
Figure 4–34 Hammering Guy Line Stakes