PROAUDIO ELECTRONICS CO. LIMITED VHF-06HHM User Manual

1. Grille(Capsule inside)
2. Power/low battery Indicator
3. Power ON/OFF/MUTE Switch
4. Battery Compartment/Cover

1

4

2

3

1. Open battery cover. Install the provided 2pcs 1.5V AA batteries and 

then close the cover. Pay attention to the correct polarity.

Push power switch to ON position, power indicator should flash 

once briefly indicating that the transmitter has sufficient power. If 
the power LED indicator stays on, it indicates that the battery has 
insufficient power and should be changed. If the power LED 
indicator does not light at all and the transmitter does not work, it 
indicates the battery is dead and you should change the battery.

If the microphone is not going to be used for any length of time, 

push power

 

switch

 

to

 

OFF

 

position

 

and

 

remove

 

the

 

battery.

2. 

3. Now receiver RF indicator should light(Please confirm frequency of 

microphone same as that of receiver before operation).

4. Push power switch to MUTE position to mute the sound.
5. During operation if power indicator lights red, this indicates the 

battery is Iow. Please replace new battery.

6. 

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC rules. Operation is subject to the following two

conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

Changes or modifications to this unit not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

The device meets RF Exposure requirements without any restriction.