Nexpro International Limitada E561 User Manual
69
Unable to
charge the
battery
charge the
battery
1.
The battery may
discharge too much; so it
cannot be charged until it
is connected for certain
time.
discharge too much; so it
cannot be charged until it
is connected for certain
time.
2.
Its performance has
worsened.
worsened.
Unable to
register to the
network
register to the
network
1.
Too weak signals or
strong interference.
strong interference.
2.
SIM card installed
properly? Bad contact or
SIM card damaged? If
the SIM card is broken,
please contact the
network operator to
replace it.
properly? Bad contact or
SIM card damaged? If
the SIM card is broken,
please contact the
network operator to
replace it.
Unable to
access
service
menus.
access
service
menus.
Maybe the SIM card does not
support service function.
support service function.
Only part of
the photo set
as standby
photo can be
seen.
the photo set
as standby
photo can be
seen.
The size of the photo may be too
big. The recommended size is
220*176
big. The recommended size is
220*176
70
7. Abbreviations
SMS
Short Message Service
EMS Enhanced
Message
Service
SIM
Subscriber Identity Module
GSM
Global System for Mobile
Communication
Communication
PIN Personal
Identity
Number
PUK
PIN Unblocking Key
IMEI
International Mobile Equipment
Identity
Identity
CB Cell
Broadcast
GPRS
General Packet Radio Service
MMS
Multimedia Message service
Card
1
1
Host card (the card inserted in SIM1
slot)
slot)
Card
2
2
Slave card (the card inserted in
SIM2 slot)
SIM2 slot)
71
Warning
FCC RF Exposure Information
and Statement:
The SAR limit of USA (FCC) is
1.6W/kg averaged over one gram of
tissue.
Product, model number: E561 (FCC
ID: ZYPE561) has also been tested
against this SAR limit. The highest
SAR value reported under this
72
standard during product certification
for use at the head is
0.812W/kg and when properly worn
on the body is 1.362W/kg. The
device was tested for typical
body-worn operations with the back
of the handset kept 1.5cm from the
body. To maintain compliance with
FCC RF exposure requirements,
use accessories that maintain a
1.5cm separation distance between
the user body and the back of the
handset .The use of belt clips,
holders and similar accessories
should not contain metallic
components in its assembly. The
use of accessories that do not