eQ-3 Limited BA1010US User Manual
9
4.3. Setting sensor address for outdoor sensor
- Commissioning and addressing the outdoor sensor is
- Commissioning and addressing the outdoor sensor is
to be performed in accordance with their respective
instructions.
instructions.
- First position the outdoor sensor near the barometer
and then carry out addressing on the barometer as
follows:
follows:
- Press the middle button on the back for approximate-
ly 2 seconds until “SEN x” appears in the display. The
“X” stands for a sensor address.
“X” stands for a sensor address.
- Using the upper button, you can now select the
address (1-8) set on the sensor.
- Once the sensor is selected, no further buttons need
to be pressed. The device exits the setting mode
automatically after about 5 seconds.
automatically after about 5 seconds.
- Now the automated synchronisation with the outdoor
sensor takes place. This process takes 6 minutes.
During this time it is not possible to operate the device.
During this time it is not possible to operate the device.
4.4. Indicators and indicator adjustment
4.4.1. Air pressure, forecast, trend
- The analogue air pressure indicator is located on
4.4.1. Air pressure, forecast, trend
- The analogue air pressure indicator is located on
the outer edge. The current air pressure (950 to
1,050 hPa) is indicated by an arrow.
1,050 hPa) is indicated by an arrow.
- In the centre below is the numerical display of this
air pressure value in an expanded range between
300 to 1,100 hPa.
300 to 1,100 hPa.
- At the top of the display the local weather forecast
is indicated by weather icons (sunny, fair, cloudy,
rain).
rain).
- At the bottom is a trend display for the air pressure