Hisense Communication Co. Ltd. C677 User Manual

 

 

9 

 

 

Note: 
Your phone is designed to be used only with Hisense Original batteries and chargers. Use of other 
batteries or charger may cause damage to your phone and void the warranty. 

New batteries are shipped partially charged. Before you can use your phone, you need to charge the 
battery, as indicated by the following instructions. 
Some batteries perform best after several full charge/discharge cycles. 
1.  Plug the travel charger into your phone’s connector port with the arrow facing up.   
2.  Plug the other end of the travel charger into the appropriate electrical outlet (100~230VAC). The 

phone’s status lamp will light blue during charge. 

3.  When your phone indicates that the battery is fully charged (status lamp turns to flash blue), and 

then remove the travel charger. 

 
Note: 
1.  Before charge, make sure the battery is installed in the phone.   
2.  The battery can discharge gradually even when your phone is powered off. If the battery is drained 

for a long time, the information stored in the phone could possibly be lost. So even you don’t need to 
use your phone for a long period, you should charge the battery some times to keep it away from 
drained. 

3.  If the status lamp flashes in red, please remove your travel charger and insert it again. If this makes 

no effect, stop charge and send the charger for repair. 

Make sure your phone is powered off so that you don’t lose any unsaved information. 
Press and hold the up flute of the battery cover and push down it to uninstall the battery cover, and then 
pull up the battery alone the dual sides’ latch to uninstall the battery.