Juster Co. Ltd. WHM6000 User Manual
2
Acknowledgment & Trademark
Manufactured under license from Dolby Laboratories “Dolby”, “Dolby Digital”, “Dolby
Pro Logic”, and the Double – D symbol are trademarks of Dolby Laboratories.
FCC Compliance Statement
The equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off and on. The user is
encouraged to try to correct the interference by one or more of the following measure:
‧
Manufactured under license from Dolby Laboratories “Dolby”, “Dolby Digital”, “Dolby
Pro Logic”, and the Double – D symbol are trademarks of Dolby Laboratories.
FCC Compliance Statement
The equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off and on. The user is
encouraged to try to correct the interference by one or more of the following measure:
‧
Reorient or relocates the receiving antenna.
‧
Increase the separation between the equipment at receiver.
‧
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
receiver is connected.
‧
Consult the dealer or an experienced radio / TV technician for help.
Notice: This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation. Shielded cables and I/O cords must be used for this equipment to
comply with the relevant FCC regulations. Changes or modifications that are not
expressly approved in writing by HC Technology Co., Ltd. May void the user’s quthorty
to operate this equipment. This digital apparatus does not exceed the Class B limits for
radio noise emissions from digital apparatus set out in the radio interference regulation of
the Canadian Department of Communication.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Table of Contents
Introduction
3
Specification
3
Package Includes
3
Safety Voltage Chart
4
Description of Parts
5
Connection Chart
6-7