Motion Research Corporation MCMSUV1 User Manual

1.  Remove the double-sided-tape backing from the clip foot base and carefully place the clip 

onto the helmet, making sue the inside foot base lip is located on the top edge of the visor. 

2.  Firmly push the clip onto the visor, using pressure on inner and outer foot base with your 

thumb and forefinger. (see fig. 7) 

3.  Fit the HDM Unit into the base. 

4.  Check the location while you are wearing the helmet. 

The pressure sensitive adhesive (PSA) will not cure completely for 24 hours, but is safe for a test 
ride within 10-15 minutes. If you placed the HDM Unit in the wrong place, the PSA will allow one 
or two removals before it loses its adhesion.  

 

 

Motorcycle Sending Unit Installation