MIER PRODUCTS INC. MIPIDA-610 User Manual
Users Manual
FCC ID: SGXMPIDA-610
The manual starts after the dotted line
----------------------------------------------------------------------------------------------------------------------------------------
The manual starts after the dotted line
----------------------------------------------------------------------------------------------------------------------------------------
WIRELESS VEHICLE DETECTION SYSTEM
MODEL DA-600 RECEIVER AND MODEL DA-610 TRANSMITTER
GENERAL INFORMATION
The Model DA-610 transmitter can be used with several receiver models, depending on intended use.
The transmitter contains the sensing electronics and should be placed in the area of moving vehicles that need
to be detected. The sensing electronics detects any disturbance in the earth’s magnetic field above a
selectable threshold. The threshold is set by a sensitivity control on the transmitter circuit board. The DA-610
transmitter is completely portable, operating on TWO size AA (LR6) alkaline or rechargeable batteries. The
transmitter includes circuitry to detect and transmit a low battery condition indicating a need to replace or
recharge the batteries. The transmitter has four user selectable address codes that must match the receiver
address codes for signal detection. The DA-610 transmitter is housed in a lockable, weather sealed steel case
with mounting brackets welded to the case.
The transmitter contains the sensing electronics and should be placed in the area of moving vehicles that need
to be detected. The sensing electronics detects any disturbance in the earth’s magnetic field above a
selectable threshold. The threshold is set by a sensitivity control on the transmitter circuit board. The DA-610
transmitter is completely portable, operating on TWO size AA (LR6) alkaline or rechargeable batteries. The
transmitter includes circuitry to detect and transmit a low battery condition indicating a need to replace or
recharge the batteries. The transmitter has four user selectable address codes that must match the receiver
address codes for signal detection. The DA-610 transmitter is housed in a lockable, weather sealed steel case
with mounting brackets welded to the case.
(picture)
The Model DA-600 receiver is a direct wireless replacement for Model DA-500 Drive-Alert. The receiver
operates on 110 volts AC with an internal 24 volt DC power supply. A relay output is provided that can be
used for control of external equipment. The relay can be used with 24 volts DC available or Form C dry
contacts. An internal piezo whistle for alarm sounding is included in the receiver cabinet. The whistle may be
switched off if desired. The DA-600 will operate the DA-505 Timer Control for extended light control, the DA-
052 Remote Whistle, X-10 PowerFlash interfaces for the DA-058 Remote Chime, or other external bells and
relays. The receiver includes a low battery lamp indicating when the DA-610 transmitter batteries need
attention. An adjustable alarm time control allows 2 seconds to 12 seconds of alarm time for each vehicle
detected. Four user selectable address switches must be set to match the code switches in the DA-610
transmitter to allow signal detection.
(pictures)
DA-600 DA-505 DA-052