Raytac Corp. MD85XXP1 User Manual
6
IMPORTANT NOTE: FCC Radiation Exposure Statement:
To comply with FCC RF exposure compliance requirements, the antenna used for this
transmitter must be installed to provide a separation distance of at least 20 centimeter from
all persons and must not be co-located or operating in conjunction with any other antenna or
transmitter.”
End Product Labeling
all persons and must not be co-located or operating in conjunction with any other antenna or
transmitter.”
End Product Labeling
This transmitter module is authorized only for use in devices where the antenna may be
installed such that 20 centimeter may be maintained between the antenna and users. The
final end product must be labeled in visible area with the following: “Contains FCC ID:
SH6MD85XXP1”
This device is intended only for OEM integrators under the following
conditions:
final end product must be labeled in visible area with the following: “Contains FCC ID:
SH6MD85XXP1”
This device is intended only for OEM integrators under the following
conditions:
The MD85XXP1 may transmit simultaneously with other collocated radio transmitters within a
host device, provided the following conditions are met:
1. Each collocated radio transmitter has been certified by FCC for mobile application.
2.
At least 20 cm separation distance between the antennas of the collocated transmitters and the
user’s body must be maintained at all times.
user’s body must be maintained at all times.
As long as 2 conditions above are met, further transmitter test will not be required. However, the
OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed.
OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed.
IMPORTANT NOTE: In the event that these conditions cannot be met (for example
co-location with another transmitter), then the FCC authorization is no longer considered
valid and the FCC ID cannot be used on the final product. In these circumstances, the OEM
integrator will be responsible for reevaluating the end product (including the transmitter) and
obtaining a separate FCC authorization. As long as a condition above is met, further
transmitter test will not be required. However, the OEM integrator is still responsible for
testing their end product for any additional compliance requirements required with this
module installed (for example, digital device emissions, PC peripheral requirements, etc.)
Manual Information to the End user
The OEM integrator has to be aware not to provide information to the end user
regarding how to install or remove this RF module in the user’s manual of the end product
which integrates this module.
The end user manual shall include all required regulatory information/warning as show in
this manual.
Antenna Restriction
which integrates this module.
The end user manual shall include all required regulatory information/warning as show in
this manual.
Antenna Restriction
The antenna is designed as permanent attached and no consideration of replacement.