Westermo Teleindustri AB GD01US User Manual
12
6696-2230
7. Installation
7.1 Mounting / Removal
Before mounting or removing the unit:
Prevent damage to internal electronics from electrostatic
discharges (ESD) by discharging your body to a grounding
point (e.g. use of wrist strap).
discharges (ESD) by discharging your body to a grounding
point (e.g. use of wrist strap).
Hazardous voltage may occur within this unit when
connected to power supply.
connected to power supply.
Prevent access to hazardous voltages by disconnecting the
unit from power supply and all other electrical connections.
unit from power supply and all other electrical connections.
Mounting
This unit should be mounted on 35 mm DIN-rail which is horizontally mounted on a wall
or cabinet backplate.
This unit uses convection cooling.To avoid obstructing the airflow around the unit,
use the following spacing rules. Recommended spacing 25 mm (1.0 inch) above/below
and 10 mm (0.4 inches) left/right the unit.
Snap on mounting, see figure
This unit should be mounted on 35 mm DIN-rail which is horizontally mounted on a wall
or cabinet backplate.
This unit uses convection cooling.To avoid obstructing the airflow around the unit,
use the following spacing rules. Recommended spacing 25 mm (1.0 inch) above/below
and 10 mm (0.4 inches) left/right the unit.
Snap on mounting, see figure
Removal
Press down the black support at the back of the unit
using a screwdriver, see figure.
Press down the black support at the back of the unit
using a screwdriver, see figure.
10 mm *
(0.4 inches)
CLICK!
!
25 mm
25 mm
* Spacing (left/right) recommended
for full operating temperature range