Hawking Technologies Inc. HSB1 User Manual
Chapter 2 Wireless LAN Access
Point Connection
1.
Choosing a location for the access point.
Usually, the best place for the access point is at the center of your
wireless network, with line of straight to all your wireless clients.
wireless network, with line of straight to all your wireless clients.
2. Adjust the antenna.
Usually the higher the antenna is placed, the better your performance will
be.
3. Connect the access point to your local area network (LAN).
Connect an Ethernet cable to the Ethernet port of the access point, and
the other end to a hub or switch. (If you are using a straight Ethernet
cable, make sure the II-X button is switched right; the other way for
Cross Ethernet cable.)
the other end to a hub or switch. (If you are using a straight Ethernet
cable, make sure the II-X button is switched right; the other way for
Cross Ethernet cable.)
4. Power on the device.
Connect the supplied
AC power adapter to the access point’s power port
and the other end to a wall outlet. (Note: Use only the included power
adapter for the Access Point. Using a different adapter may cause
damage to the product.)
adapter for the Access Point. Using a different adapter may cause
damage to the product.)
The Hardware Installation is now complete.
Please follow the steps below to configure the Access Point.