Hawking Technologies Inc. HSB1 User Manual

Page of 35
1.  Click the Start button and select Settings, then click Control Panel. The  Control 
Panel window will appear. 
2.  Double-click Network  icon. The Network  window will appear. Select the Protocol 
tab from the  Network  window. 
3.  Check if the TCP/IP Protocol is on your list of Network Protocols. If TCP/IP is not 
installed, click the Add button to install it now. If TCP/IP is installed, go to  step 5
4.  In the Select Network Protocol window, select the TCP/IP Protocol and click the 
Ok      button to start installing the TCP/IP protocol. You may need your 
Windows CD to     complete the installation. 
5.  After you install TCP/IP, go back to the Network  window. Select TCP/IP from the 
list of Network Protocols and then click the Properties button. 
6.  Check each of the tabs and verify the following settings: 
 
?
 
IP Address: Select Specify an IP address. Specify the IP Address and 
Subnet Mask as following example. 
IP Address: 192.168.1.3 (any IP address within 
192.168.1.2~192.168.1.254 is available, do not setup 192.168.1.1, 
or 192.168.1.240
Subnet Mask: 255.255.255.0 
 
DNS: Let all fields are blank. 
 
WINS: Let all fields are blank. 
 
Routing: Let all fields are blank. 
7.  Click OK to confirm the setting. Your PC will now have the IP Address you 
specified. 
 
2.  Open the web browser, enter the local port IP address of the access 
point (default at 192.168.1.240), and click “Go” to access the login 
page. 
 
3.  A screen will pop up and prompt for user name and password entry. 
The default user name and password is as follows: 
User Name: Admin 
Password: 1234 
Type in the default user name and password, then press the OK button.