Innovative Wireless Technologies Inc FAP4213210 User Manual
Revised: 9/25/2018
6650-16-0013, Rev. D
Page 5 of 15
This radio transmitter
IC: 9568A-FAP4213210 has been approved by Innovation, Science and
Economic Development Canada to operate with the antenna types listed below, with the maximum
permissible gain indicated. Antenna types not included in this list that have a gain greater than the
maximum gain indicated for any type listed are strictly prohibited for use with this device.
permissible gain indicated. Antenna types not included in this list that have a gain greater than the
maximum gain indicated for any type listed are strictly prohibited for use with this device.
The approved antenna types that may be used are:
1) Directional yagi antenna with a maximum gain of +11 dBi
2) Omni-directional dipole antenna with a maximum gain of +5 dBi
2) Omni-directional dipole antenna with a maximum gain of +5 dBi
IMPORTANT:
• To comply with FCC radio frequency (RF) exposure compliance requirements, the antenna used
for this transceiver must not be co-located or operating in conjunction with any other antenna
or transceiver.
• The SENTINEL™ Integrated Mesh Node must be installed 20 cm or more from any personnel in
order to comply with FCC
and ISED exposure requirements.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate RF
energy which may cause harmful interference to radio communications if not installed and used in
accordance with the instructions. It is important to note that proper installation does not guarantee
interference will not occur. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate RF
energy which may cause harmful interference to radio communications if not installed and used in
accordance with the instructions. It is important to note that proper installation does not guarantee
interference will not occur. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna;
Increase the separation between the equipment and receiver;
Connect the equipment into an outlet on a circuit different from that to which the receiver is
Increase the separation between the equipment and receiver;
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected; or
Consult the dealer or an experienced radio technician for help.