Inscape Data Co. AGNVC110W User Manual
NVC100/110 User’s Manual
33
33
33
33 of
of
of
of 51
51
51
51
- Type Selection: Select sensor type. There are two types of sensors
. Normal Open: “floating” in normal situations, non-floating means an alarm condition.
. Normal Close: “non-floating” in normal situations, floating means an alarm condition.
. Normal Close: “non-floating” in normal situations, floating means an alarm condition.
#
Video Capture Condition
: Sets the condition of the video recording and transmission via FTP or
E-mail. The NVC100/110 supports 3 types of conditions:
1. Sensor: When at least one of the sensors detects an alarm condition.
2. Motion-detected: When motion is detected from the video channel.
3. Periodic: Video is recorded during pre-defined time zone.
2. Motion-detected: When motion is detected from the video channel.
3. Periodic: Video is recorded during pre-defined time zone.
The above 3 conditions are mutually independent in operation.
# Sensor Select: Select the sensor that triggers video capture.
# Motion Detection Select: Select the video channel that triggers video capture.
# Periodic Transfer Select: Set the pre-defined time for periodic video capture.
#
Captured Video Transmission
: Select a way of sending captured video. You can send
captured video through FTP or E-mail, or both.
- FTP is sent to the FTP Server. Refer to
[Section 5.3.]
-
E-mail is sent to the Recv E-mail address. Refer to
[Section 5.3.]
If the FTP server is not properly assigned in Network Configuration mode, the
NVC100/110 ignores the video transmission by FTP
NVC100/110 ignores the video transmission by FTP
Captured video data for E-mail consists of intra frames only in consideration of the
limited storage space for E-mail account. FTP data contains entire video frames
limited storage space for E-mail account. FTP data contains entire video frames
.
Video for periodic recording is sent only to the FTP server.