Shanghai Huace Navigation Technology LTD. A01002 User Manual
Appendix
X90 GNSS – 1.01 Rev A – September 2010
14
5. Configuration
●
Static Configuration
●
RTK Configuration
5.1 Static Configuration
There are 3 ways to configure the receiver in Static Mode.
A. Using RS232 Port and HCLoader Software in the Office
First, connect X90GNSS to your computer through RS232 line.
Second, run the software HCLoader and click icon Link to make the
receiver connected with computer.
Third, click icon Setup to set the sample interval (15S is
recommended) and mask angle of the receiver (13 is recommended)
and choose the Data Log mode as Auto, then click Apply to make
the configuration work and click Exit.
Fourth, restart the receiver.
B. Using PDA and Software HCGPRSSet in the Field
First, use RS232 port connecting PDA with receiver.
Second, tap the icon HCGPRSSet on the PDA.
Third, click Open then you will see this picture, set the sample
interval (15S is recommended and mask angle of the receiver (13 is
recommended) you want and choose the data log mode as Auto,
then click Apply to make the configuration works.
Fourth, restart the receiver.
C. Switch Button in the Field
The information has been introduced in Chapter 3.3.1
A. Using RS232 Port and HCLoader Software in the Office
First, connect X90GNSS to your computer through RS232 line.
Second, run the software HCLoader and click icon Link to make the
receiver connected with computer.
Third, click icon Setup to set the sample interval (15S is
recommended) and mask angle of the receiver (13 is recommended)
and choose the Data Log mode as Auto, then click Apply to make
the configuration work and click Exit.
Fourth, restart the receiver.
B. Using PDA and Software HCGPRSSet in the Field
First, use RS232 port connecting PDA with receiver.
Second, tap the icon HCGPRSSet on the PDA.
Third, click Open then you will see this picture, set the sample
interval (15S is recommended and mask angle of the receiver (13 is
recommended) you want and choose the data log mode as Auto,
then click Apply to make the configuration works.
Fourth, restart the receiver.
C. Switch Button in the Field
The information has been introduced in Chapter 3.3.1