Homewerks Worldwide LLC 7130-06-BTN User Manual

Ceiling

Opening (L)

Ceiling

Opening (W)

Ceiling

Opening (H)

9.4 in.

7.4 in.

Housing

Dimension (L)

Housing

Dimension (W)

Housing

Dimension (H)

9.25 in.

7.375 in.

PREPARATION

Tools Required for Assembly (not included): Hammer, Flathead Screwdriver, Wire Nuts, Nails, Duct Tape,

Phillips Head Screwdriver, Utility Knife or Drywall Saw,

Helpful Tools (not included): Electric Drill, Drill Bits

WARNING: Turn off electricity at breaker box before beginning installation.

Carefully remove unit from carton.

*Before removing your current ventilation unit, verify your switch box on the wall has the required supply

wires necessary for this install. These supply wires are power/black and nuetral/white (refer to right
side of wiring diagram below) at the switch. If you do not see both of these wires, consult a licensed
electrician for install.

Check area above installation location to be sure that wiring can run to the planned location and that
duct work can be run and the area is sufficient for proper ventilation.

Inspect duct work and wiring before proceeding with installation.

Before installation, provide inspection and future maintenance access at a location that will not interfere
with installation work.

You may need the help of a second person to install this fan; one person on the attic side and one on
the room side.

Note: Installations may vary depending on how the previous bath fan was installed. Supplies necessary
for the installation of your bath fan are not all included; however, most are available at your local
home improvement or hardware store.

DIMENSIONS REQUIREMENTS

WIRING DIAGRAM
All wiring must be connected for full functionality. Do not use metal wall plate with switch.

green ground

black switch
connection

black power

www.homewerksww.com

white neutral

house/white neutral