Tyco Safety Products / Software House PI26 User Manual

When using properly grounded and shielded cabling for monitor point and 
control point wiring, the apC/8X meets the requirements for an FCC Class B 
device, and the following notice applies. 

Note: This equipment has been tested and found to comply with the 

limits for a Class B digital device, pursuant to Part 15 of the FCC 
rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. The 
equipment generates, uses, and can radiate radio frequency 
energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio 
communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this 
equipment does cause harmful interference to radio or television 
reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference 
by one or more of the following measures:

– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from 

that to which the receiver is connected. 

– Consult the dealer or an experienced radio/TV technician for 

help.