Foreign Trade Corporation dba. Technocel T160 User Manual

While in standby mode, the LED is OFF. When the 

device is first placed on the pad, the LED blinks 

3x indicating a wireless connection has been made. 

When power transfer begins the LED will turn solid. 

At the end of charge the LED will turn off.

If the white LED is blinking but the device is not 

charging, there may be a metal object nearby. Pick 

up the device and remove the foreign object and 

place device back on the wireless charger. This is a 

safety feature and normal operation. 

Standby

Charging

LED indicator light

CAUTIONS

The Wireless Charging Pad works with Qi Wireless 

Charging compatible smartphones and devices. 

The charging unit should only be used at normal indoor 

room conditions. 

Place charger on a hard flat surface. 

Use the Type-C power supply that is included with 

the Wireless Charging Pad, which requires 15V, 1.5A 

to operate. 

The Verizon Wireless Charging Stand and your 

smartphone/device may become warm during charging. 

Avoid direct contact with highly flammable materials. 

WIRELESS 

CHARGING PAD

Power-up the Wireless Charging Pad by inserting 

the Type-C connector into the power port and plug 

the power adapter into the wall. Only use the Type-C 

power adapter that was included with the device. 

Place your Qi™ compatible device on the 

Wireless Charging Pad to begin charging.

CARE AND MAINTENANCE 

Keep Device Dry. Do NOT expose the device to liquids. 

If device gets wet, immediately unplug it and allow it to 

dry. Do not disassemble or attempt repair. Do not store 

the device in high or low temperatures. Do not store the 

device in temperatures below 20F or above 160F. Do not 

use product in temperatures under 0F or above 95F. 

Indoor use only.

Place charger on a dry, 

clean, flat, smooth surface.

Input: USB Type-C, 15V 1.5A
Output: up to 15W

Wireless Charging Pad
Type-C Power Supply

FCC Information

This equipment has been tested and found to comply with the limits for 

a Class B digital device, pursuant to Part 15 of the FCC Rules.  These 

limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, 

uses and can radiate radio frequency energy and, if not installed and 

used in accordance with the instructions, may cause harmful 

interference to radio communications. However, there is no guarantee 

that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the 

equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that 

to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules 

[and with RSS-216 of Industry Canada].

Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including 

interference that may cause undesired operation.

To comply with FCC and other RF exposure requirements, please 

maintain a distance of 10cm between the charger and your body 

when in use.

This transmitter must not be co-located or operating in conjunction 

with any other antenna or transmitter.

Changes or modifications to this unit not expressly approved by the 

party responsible for compliance could void the user’s authority to 

operate the equipment.

FCC ID: SZQ-T160

charging cord

IC3745