YEALINK NETWORK TECHNOLOGY CO. LTD. T29G User Manual

Accessing the web user interface:

Account Settings: 

Click on

Account->Register->Account X (X=1,2,3...15,16)

Parameters of the account:

Network Settings:

Account Settings:

Configuring via phone user interface

Configuring via web user interface

Register status icons on the LCD screen:

1. Press the OK key when the phone is idle to obtain the IP address of the phone. 

You can configure the network settings in the following ways:

It shows the register status of the current account.

You can select Enabled/Disabled to enable/disable the account.
It is shown on the LCD screen to identify the account.
It is shown as caller ID when placing a call.
It is provided by ITSP for registration (required).

It is an authenticated ID for authentication provided by ITSP (required).
It is provided by ITSP for registration (required).

It is provided by ITSP for registration (required).

DHCP:

 

By default, the phone attempts to contact a DHCP server in your network to obtain its valid network settings, 

         e.g., IP address, subnet mask, gateway address and DNS address.
Static IP Address: If your phone can not contact a DHCP server for any reason, you need to configure the IP address, 
                     subnet mask, gateway address, primary DNS address and secondary DNS address for the phone 
                     manually.

PPPoE:

 

If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE mode. Contact the 

         ITSP for the account and password.

Press the

 

Menu

 

soft key when the phone is idle, select

 

Advanced (password: admin)->Network-> WAN Port/VLAN/Web Server/

802.1x /VPN/LLDP/CDP/NAT

 

to configure the network.

Press the

 

Menu

 

soft key when the phone is idle, select

 

Advanced (password: admin)->Accounts to configure the 

account. 

2. Open a web browser on your computer, enter the IP address into the address bar (e.g., "http://192.168.0.10" 
    or "192.168.0.10") and then press the Enter key.

Register Status:            
Line Active:            
Label:                          
Display Name: 
User Name: 
Register Name: 
Password: 
Server Host: 

3. Enter the user name (default: admin) and password (default: admin) in the login page and click Confirm

.

Network Settings:  Click on

Network->Basic->IPv4 Config

Registered

Register Failed

Registering

(Gray)

(Green)

(Yellow)

4

Configuring Your Phone

Note:

 

Wrong network settings may result in the inaccessibility of your phone and may have an impact on the 

         network performance. Contact your system administrator for more information.

Note:

 

Check with your system administrator if any error appears during the registration process or a specific 

         configuration is required for your registration.

Note:

 

For more information on account parameters, refer to

 

Configuring via web user interface.