YEALINK NETWORK TECHNOLOGY CO. LTD. T48S User Manual

Accessing the web user interface:

Account Settings: 

Click on

Account->Register->Account X (X=1,2,3...15,16)

Parameters of the account:

Configuring via web user interface

Register status icons on the LCD screen:

1. Press the OK key when the phone is idle to obtain the IP address of the phone. 

You can configure the network settings in the following ways:

It shows the register status of the current account.

You can select Enabled/Disabled to enable/disable the account.
It is shown on the LCD screen to identify the account.
It is shown as caller ID when placing a call.

It is provided by ITSP for registration (required).
It is an authenticated ID for authentication provided by ITSP (required).
It is provided by ITSP for registration (required).

It is provided by ITSP for registration (required).

DHCP:

 

By default, the phone attempts to contact a DHCP server in your network to obtain its valid network settings, 

        e.g., IP address, subnet mask, gateway address and DNS address.

Static IP Address: If your phone cannot contact a DHCP server for any reason, you need to configure the IP address, 
                   
                   

PPPoE:

 

If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE mode. Contact the 

         

2. Open a web browser on your computer, enter the IP address into the address bar (e.g., "http://192.168.0.10" 
    or "192.168.0.10") and then press the Enter.

Register Status:            
Line Active:            
Label:                          
Display Name: 
User Name: 
Register Name: 
Password: 
Server Host: 

3. Enter the user name (default: admin) and password (default: admin) in the login page and click Confirm

.

Network Settings:  Click on

Network->Basic->IPv4 Config

3

Configuring Your Phone

Note:

 

Check with your system administrator if any error appears during the registration process or a specific 

         

Note:

 

For more information on account parameters, refer to

 

Configuring via web user interface above. 

subnet mask, gateway address, primary DNS address and secondary DNS address for the phone 
manually.

ITSP for the PPPoE user name and password.

configuration is required for your registration.

Note:

 

The IP phone also supports IPv6, but IPv6 is disabled by default.

         Wrong network settings may result in the inaccessibility of your phone and may have an impact on the 
         network performance. Contact your system administrator for more information. 
         

Registering

 Registered

Register Failed

(Green)

(Gray)

(Green and Flashing)  

Configuring via phone user interface
Network Settings:
When the phone is idle, tap         ->Advanced (default password: admin)->Network->WAN Port/VLAN/Webserver Type/802.1x/VPN/ 
LLDP/CDP/NAT to configure the network.
Account Settings:
When the phone is idle, tap         ->Advanced (default password: admin)->Account to configure the account.