ASOKA USA Corporation 3050 User Manual

AsokaUSA PlugLAN

TM

 3050 User’s Manual 

 

V1.01a 

Tel: 

+1 650 286 1700

2344-A Walsh Avenue Santa Clara, CA 95051 USA

  

Fax: 

+1 650 286 1790

                      

                                                                                                                                              URL: 

www.asokausa.com

 

a. Connect 3050 to AC power with wires P1 (Phase1) and N (Neutral), please see 

Figure 1. 

b. Connect 3050 to a PC or Laptop with CAT5 cable through RJ45 port. 
c. Set network configuration of PC to communicate with 3050. The default IP 

address of 3050 is as below: 

z  Default LAN IP address:    192.168.1.250 

d. Power on 3050, Use command “ping” in PC side to test the connection 

between the Gateway and PC. For example, you connect PC to LAN port, the 
IP address of PC should be set to “192.168.1.x” (1<x<255 and x!=253), the 
network mask is “255.255.255.0”.   

a. Set the CTs: make the AC wires which we need monitor through CTs. 
b. Set 3050 in the AC power panel box and Connect wires of CTs to 3050 as 

Figure 2. 

c. Connect 3050 and AC power with wires P1 (Phase1), P2 (Phase2), P3 (Phase3) 

and N (Neutral) as Figure 2.   

d. The device is powered on when LED power light, see Figure 1. 
e. The PLC signal have been received when LED plc flash, see Figure 1. 
 

 

Figure1. 3050 silkscreen