Gigaset Communications GmbH SX686 User Manual
28
Quick Start Guide
Gigaset SX686 WiMAX / de-en / A31008-N919-R101-2-ZD43_22-10-2008 / qig_SX686_685.fm / 23.10.2008
Te
m
plat
e 2004
_12
_27
Connecting to the mains power supply
The system starts up and performs a self-test. After the self-test, the Gigaset SX686
WiMAX continually attempts to register with a WiMAX network. Registration may be
successful immediately. If not, registration will take place when the Gigaset SX686
WiMAX is being configured. You can check whether your device is already registered
with a WiMAX network via the Status LED.
WiMAX continually attempts to register with a WiMAX network. Registration may be
successful immediately. If not, registration will take place when the Gigaset SX686
WiMAX is being configured. You can check whether your device is already registered
with a WiMAX network via the Status LED.
Connecting PCs wirelessly
A wireless connection is made using a wireless network adapter that must be installed
in your PC.
in your PC.
Wireless via WPS
If you are using WPS, you can easily make a wireless connection to other WLAN devices.
If you are using WPS, you can easily make a wireless connection to other WLAN devices.
ì
Activate the WPS registration via the corresponding function in the user interface to
start WPS registration (see page 33).
start WPS registration (see page 33).
ì
During the two-minute interval, activate WPS registration of the wireless network
adapter on the PC. The client receives the security data for the Gigaset SX686
WiMAX (SSID and pre-shared key) and is thereby registered.
adapter on the PC. The client receives the security data for the Gigaset SX686
WiMAX (SSID and pre-shared key) and is thereby registered.
Note:
You cannot make VoIP calls in the event of a power failure. Emergency numbers are
also not accessible in this case.
You cannot make VoIP calls in the event of a power failure. Emergency numbers are
also not accessible in this case.
Please remember:
Only use the mains adapter supplied with the device (12V DC 2A).
Only use the mains adapter supplied with the device (12V DC 2A).
ì
Connect the mains adapter cable
to the Power socket on the
Gigaset SX686 WiMAX.
to the Power socket on the
Gigaset SX686 WiMAX.
ì
Plug the mains adapter into a
mains socket.
mains socket.
The Gigaset SX686 WiMAX is now
switched on and ready for operation.
switched on and ready for operation.