Andante Medical Devices Ltd. SMARTSTEP0106 User Manual
Preparing a Session
Check Air Pressure - Inflate the Insole if Necessary
48 | SmartStep™ Verson 2.1.1 Revision A2
4 Preparing
a
Session
4.1
Check Air Pressure - Inflate the Insole if
Necessary
Necessary
The insole needs to be inflated before the first session with each patient. The exact
pressure is unimportant at this time, it is merely necessary in order to place the
insole inside the shoe. Check that the insole is inflated. If not, connect it to the
Control Unit (see section 4.6 below) and inflate the insole's air pockets - the process
is detailed below.
pressure is unimportant at this time, it is merely necessary in order to place the
insole inside the shoe. Check that the insole is inflated. If not, connect it to the
Control Unit (see section 4.6 below) and inflate the insole's air pockets - the process
is detailed below.
Insole, Control Unit and Air Pump
To inflate the insole:
There are two metal tube sockets, located on each side of the Control Unit.
1. Insert the pump into one socket. Inflate the air pocket. Once the air pocket is
inflated
,
remove the pump from the socket by pulling the grooved tube
upwards.
2. Repeat the above process for the other socket.
3. Disconnect the insole from the Control Unit.
3. Disconnect the insole from the Control Unit.
To disconnect the insole from the Control Unit, twist the connectors counter-
clockwise.