Impinj Inc. IPJR640 User Manual
Speedway Revolution Installation and Operations Guide Octane 4.4
Chapter 2: Installing and Connecting
Chapter 2: Installing and Connecting
8
Copyright © 2010, Impinj, Inc.
The following table describes the LED behavior for various reader states:
Table 2.1: Reader Operations and Associated LED Behavior
Reader Operation
LED
Expected Behavior
Power
Solid red
Power applied,
attempting to start boot
code
attempting to start boot
code
Status
Off
Power
Solid green
Bootloader calling firm-
ware image
ware image
Status
Off
Power
Solid green
Startup (power on),
normal completion
normal completion
Bootloader completed
successfully, reader is
ready
successfully, reader is
ready
Status
Solid green
Power
Turns off
Factory Default Restore
button pressed
button pressed
Status
Off
Startup (reset),
normal completion
normal completion
Factory Default Restore
button pressed for 3
seconds
button pressed for 3
seconds
Power
Blinks once (red), indicates a
configuration default restore will
occur
configuration default restore will
occur
Power
Continuous blinking red
Startup (failure)
Hardware problems
detected, unable to boot Status
detected, unable to boot Status
Off
Upgrade activity
Upgrading the firmware
during boot process
during boot process
Status
Alternates between red and
green
green
Detects no activity on
antenna port
antenna port
Antenna
Off
Detection of
antenna activity
antenna activity
Detects antenna
transmission activity on
antenna port
transmission activity on
antenna port
Antenna
Solid green
Inventory activity
Performing an inventory
operation
operation
Status
Blinks orange, blinks faster as
tag volume increases
tag volume increases
LLRP activity
Active LLRP connection
Status
Double blink pattern (green)
LLRP activity
Disconnected operation
Status
Single blink pattern (green)
Installing and Connecting the Reader
The primary installation and connection steps for Speedway Revolution are:
1. Position the reader appropriately for your environment. This may or may
not involve mounting the reader.
2. Connect the antenna(s) to the appropriate ports on the reader.
3. Connect power to the reader.
4. Connect the reader to the network.
5. Test the reader installation by reading tags.
3. Connect power to the reader.
4. Connect the reader to the network.
5. Test the reader installation by reading tags.