Impinj Inc. XARRAY User Manual
Speedway Revolution Installation and Operations Guide Octane 4.11
Appendix C: Speedway xPortal Installation
Revision 4.11 Copyright © 2014, Impinj, Inc.
55
8 total holes with M4 threads
Outer square pattern is 100mm on each side
Inner square pattern is 75 mm on each side
¼ inch diameter bolt with 20 threads per inch (¼-20) internally threaded studs
2. Common hardware using ¼-20 hardware. This hardware is typically employed in
most T-slot extrusion designs (see http://www.8020.net/). Show in the Green
circles on the figure.
circles on the figure.
3. Keyhole slots and through-holes. Holes are sized to allow clearance for ¼-20 screws.
These holes allow you to mount the unit flush to a wall. Shown in the Blue ovals on
the figure.
the figure.
It is your responsibility to determine if the chosen screws can support the weight of the
xPortal. Since the xPortal weighs approximately 6.5 pounds (3kg), it can be installed on
drywall without needing to locate studs.
The yellow circles on the figure highlight two knock-outs that can be removed if you wish to
run cables into the unit directly from the wall. This provides a very clean installation, with
no cables visible from the front.
xPortal. Since the xPortal weighs approximately 6.5 pounds (3kg), it can be installed on
drywall without needing to locate studs.
The yellow circles on the figure highlight two knock-outs that can be removed if you wish to
run cables into the unit directly from the wall. This provides a very clean installation, with
no cables visible from the front.
Figure C.2 xPortal Mounting Hole Types and Locations