LogicMark LLC CS40915 User Manual
v3.10
CaretakerSentry®
9
Note: If you don’t have an open line when you begin to program the System with your telephone - the phone
company will think you are trying to dial an outside number and will try to complete the call. By having the
phone line already in use with your cell phone or other called party - you are now ready to program the System.
Step 3: With the phone connection established in Step 2, slide the slide switch at the back of the Base unit
to Programming Mode. You will hear an audible announcement of this position.
Step 4: Start programming the System. Push the numbers slowly and listen to the voice prompts. Follow the
next steps to enter the numbers.
NOTE: The “#” key (the key in the lower right corner of your phone keypad) must be entered after the passcode,
NOTE: The “#” key (the key in the lower right corner of your phone keypad) must be entered after the passcode,
after each central station number, and after the account code as shown in the steps below. Do not ignore
the “#” key.
Central Station Number, Account Code, Caretaker Telephone Number Programming:
Note: You will be using your telephone keypad on an open telephone line to program the System numbers.
The base will speak each number that is pushed on the telephones keypad. You DO NOT have to program a
secondary (or back-up) central station telephone number, but we highly recommend it.
1. Call your cell phone from the telephone on the same line as the Base unit. Answer your cellphone
1. Call your cell phone from the telephone on the same line as the Base unit. Answer your cellphone
and keep this line open for the following steps.
2. Slide Programming switch to Programming Mode
3. Enter (Passcode) – XXXX then “#” (Default is “1 2 3 4”)
[Voice prompt– Enter 1st phone number followed by “#”]
4. Enter primary central station number – X XXX XXX XXXX then “#”
[Voice prompt – Enter 2nd phone number followed by “#”]
4. Enter primary central station number – X XXX XXX XXXX then “#”
[Voice prompt – Enter 2nd phone number followed by “#”]
5. Note: to skip secondary phone number - just enter “#” again
6. Enter secondary central station phone number
X XXX XXX XXXX then “#”
[Voice prompt – Enter 4 digit account number]
7. Enter 4 digit account number – AAAA then “# “ (account number must be 4 digits long – no letters)
7. Enter 4 digit account number – AAAA then “# “ (account number must be 4 digits long – no letters)
[Voice prompt – Enter Caretaker number]
8. Enter Caretaker Number – – X XXX XXX XXXX then “#”
8. Enter Caretaker Number – – X XXX XXX XXXX then “#”
[Voice prompt – Programming complete]
(This Caretaker number is the non-emergency number that the CaretakerSentry can call. This is generally
programmed with a nurse or caregiver telephone number. To skip and not program a Caretaker number
– just enter “#” again. If no number is programmed, the Caretaker button will work the same as the
Emergency button)
8. Slide Programming Switch to Normal Operation (“Emergency Call Mode”)
To Change the 4 Digit Passcode:
The factory default for the programming passcode is “1 2 3 4”. If you wish to change this passcode to prevent
unauthorized re-programming, simply follows these steps:
1. Establish a phone line as you did in Step 2 on page
7. Slide programming switch to Programming Mode.
2. Enter “1 2 3 4” or your old Passcode
XXXX then “
* # * #
”
[Voice prompt – Enter New Passcode ]
3. Enter “Y Y Y Y” (your new passcode) then “#”
[Voice prompt – Programming complete]