Resolution Products Inc. RE108 User Manual
RE108_Hardwire_to_GE-Compat_Translator.doc
Page 1 of 3
21-Sep-09
www.ResolutionProducts.com
Wireless
Security
Solutions
RE108 Hardwire to Wireless Takeover Translator, GE-Compatible
Features
•
Converts hardwire zones into GE-compatible wireless signals.
•
8 Hardwire loops with end-of-line resistor detection.
•
Unique wireless ID (or loop) for each zone, plus 1 for main device.
•
Transmit diversity for long reliable range.
•
PIR powering (via external supply).
•
Back-up battery operation.
•
Complete supervision of tampers, external power supply fault and low
battery.
battery.
Key Instructions
•
Use with normally closed contacts in-line with 4.7 K-ohms end-of-line
resistors.
resistors.
•
4-wire PIRs only.
•
External supply: 7-14V AC or DC at least 50 mA.
•
PIR usage: Adds requirements to external supply – see Specifications.
•
2 AAA Alkaline batteries are for backup in case of external supply
failure. Backup batteries cannot drive the PIR.
failure. Backup batteries cannot drive the PIR.
•
Enrolling:
Loops enrolled by tampering (shorting).
Main device enrolled by tamper switch on the board.
Operation
•
8 Hardwire Zones wireless transmissions (8 unique IDs):
Alarm, when Device sees open circuit.
Tamper, when device sees short circuit.
Supervisories, every hour for each zone.
Tamper, when device sees short circuit.
Supervisories, every hour for each zone.
•
Translator Main Zone wireless transmission (9
th
unique ID):
Tamper, when cover opened.
Low battery, when either low AAA batteries, OR loss of AC.
Supervisory every hour.
Low battery, when either low AAA batteries, OR loss of AC.
Supervisory every hour.
•
LED Operation
Green LED: On if AC power present.
Red LED:
Red LED:
On if device tamper or device low battery