IDS GeoRadar Srl SRS-FW400 User Manual
IDS Ingegneria Dei Sistemi S.p.A.
Protocol: MN/2009/030 - Rev. 1.2
Safe Rail System Data Acquisition Software
43
/
76
Fig. 4-20 –Advanced S ettings window
•
T he
Ground type
field en ables y ou to activate the
Rough terrain
option
if necessary . When this option is activated, the radar data are temp orarily
saved on the sele cted
saved on the sele cted
Device
during the acquisition p hase. You can eve n
select an e xternal
Device
such as a flash me mory to temp orarily save the
data during the a cquisition p hases. T his option is recommend ed w hen the
ground conditions are p articularly rough, and w hen y ou may find that
saving the data durin g the acquisition p hase becomes cr itical du e to the
high nu mber of vibr ations in the system.
ground conditions are p articularly rough, and w hen y ou may find that
saving the data durin g the acquisition p hase becomes cr itical du e to the
high nu mber of vibr ations in the system.
•
In the
Measure unit
field, y ou can choose the measurement units to be
app lied to the radar map visualiz ed in re al tim e. T he a lternatives are
m/cm
and
foot/inch
•
In the
Wiggle sweep
field,
y ou can select the p arameters for visualisin g the
acquired d ata in rea l time in Wiggle mode ;
o
S cale
rep resents the signal amp lification
(intended as the number o f
p ixels into w hich the -10V a +10 V vector scale is map p ed),
o
N. trace
rep resents the “ x” interval
of the view ed traces (i.e. that
one sw eep is view ed every “ x” traces),
o
Trace offset
is on the other hand the r ep resentation interval
betw een adjoinin g trac es (i.e. a lso in this case the number of p ixels)
o
Default
Buttons
saves the p reset settings as the default
configuration.
•
In the
S wap axis
field, y ou have the choice of modify in g the vertic al sc ale
of the radar map by setting the value in
m
or
nsec
•
In the
Gain application
field, y ou can choose to view the radar map
acquired in rea l time w ith or w ithout gain ap p lied
•
In the
Background removal field
y ou can set the Clear_x ap p lication for
the acquired rad ar map s.
•
In the
Display enable
y ou can activate the disp lay mode of the radar
section during acquisition p hase.