Arris TG1682-3 User Manual
Xfinity TG1682 Telephony Gateway User's Guide
4
A R R I S
Getting
Battery
Ethernet
Safety
Started
Installation
Installation
Configuration
Usage
Troubleshooting
Glossary
Do not use spray cleaners or aerosols on the Telephony Gateway.
The product shall be cleaned using only a damp, lint-free, cloth. No solvents or
cleaning agents shall be used.
cleaning agents shall be used.
Avoid using and/or connecting the equipment during an electrical storm, to
avoid risk of electrocution.
avoid risk of electrocution.
Do not use the telephone to report a gas leak in the vicinity of the leak.
Do not locate the equipment within 6 feet (1.9 m) of a flame or ignition source
(i.e. heat registers, space heaters, fireplaces, etc.).
(i.e. heat registers, space heaters, fireplaces, etc.).
Use only power supply and power cord included with the equipment.
Equipment should be installed near the power outlet and should be easily
accessible.
accessible.
The shield of the coaxial cable must be connected to earth (grounded) at the
entrance to the building in accordance with applicable national electrical in-
stallation codes. In the U.S., this is required by NFPA 70 (National Electrical
Code) Article 820. In the European Union and in certain other countries, CATV
installation equipotential bonding requirements are specified in IEC 60728-11,
entrance to the building in accordance with applicable national electrical in-
stallation codes. In the U.S., this is required by NFPA 70 (National Electrical
Code) Article 820. In the European Union and in certain other countries, CATV
installation equipotential bonding requirements are specified in IEC 60728-11,
Cable networks for television signals, sound signals and interactive
services,
Part 11: Safety. This equipment is intended to be installed in
accordance with the requirements of IEC 60728-11 for safe operation.
If the equipment is to be installed in an area serviced by an IT power line
network, as is found in many areas of Norway, special attention should be
given that the installation is in accordance with IEC 60728-11, in particular
Annex B and Figure B.4.
network, as is found in many areas of Norway, special attention should be
given that the installation is in accordance with IEC 60728-11, in particular
Annex B and Figure B.4.
In areas of high surge events or poor grounding situations and areas prone
to lightning strikes, additional surge protection may be required (i.e.
PF11VNT3 from American Power Conversion) on the AC, RF, Ethernet and
Phone lines.
to lightning strikes, additional surge protection may be required (i.e.
PF11VNT3 from American Power Conversion) on the AC, RF, Ethernet and
Phone lines.
When the Telephony Gateway is connected to a local computer through Eth-
ernet cables, the computer must be properly grounded to the building/res-
idence AC ground network. All plug-in cards within the computer must be
properly installed and grounded to the computer frame per the manufacturer's
specifications.
ernet cables, the computer must be properly grounded to the building/res-
idence AC ground network. All plug-in cards within the computer must be
properly installed and grounded to the computer frame per the manufacturer's
specifications.