Mitel Deutschland GmbH 68635RFP36U-01 User Manual
Maintenance
325
8 MAINTENANCE
8.1 SITE SURVEY MEASUREMENT EQUIPMENT
If a SIP-DECT installation must be planned, a sufficient distribution of DECT base stations that meets the
requirements for reliable synchronization and connectivity to the DECT phones is necessary. The site
survey kit may help you. It comprises:
requirements for reliable synchronization and connectivity to the DECT phones is necessary. The site
survey kit may help you. It comprises:
•
One measuring RFP with its own power supply.
•
A tripod and a battery for the RFP.
•
Two reference DECT phones with chargers.
•
Battery chargers.
•
Optional a measuring DECT phone which can monitor other makers DECT radio sources.
8.2 CHECKING THE MITEL HANDSET FIRMWARE VERSION
You can display the version information of a Mitel 600 or Mitel 142d DECT phone with a few keystrokes.
Check the firmware version to determine whether an update is required to overcome any user issues.
1 Press the Menu soft key.
2 Select System (only to highlight).
3 Press OK.
4 Select Version Number.
5 Press OK.
The display shows the software and the hardware version of the Mitel DECT phone.
Check the firmware version to determine whether an update is required to overcome any user issues.
1 Press the Menu soft key.
2 Select System (only to highlight).
3 Press OK.
4 Select Version Number.
5 Press OK.
The display shows the software and the hardware version of the Mitel DECT phone.
8.3 DIAGNOSTIC
8.3.1 MITEL DECT PHONE SITE SURVEY MODE
You can switch a Mitel 600 or Mitel 142d DECT phones into “site survey mode” with a few keystrokes. In
this mode the phone will display the RFPs and the actual field strength of the receiving signal in dBm.
1 Press the Menu soft key.
2 Enter the following key sequence “***76#” (Mitel 600 ) or “R***76#” (Mitel 142d).
3 Select Site Survey.
4 Press OK.
5 To leave the site survey mode, switch the phone off and on again.
The following display is shown on the Mitel DECT phone:
this mode the phone will display the RFPs and the actual field strength of the receiving signal in dBm.
1 Press the Menu soft key.
2 Enter the following key sequence “***76#” (Mitel 600 ) or “R***76#” (Mitel 142d).
3 Select Site Survey.
4 Press OK.
5 To leave the site survey mode, switch the phone off and on again.
The following display is shown on the Mitel DECT phone: