Simplex Time Recorder Company 325320 User Manual
P/N IM-300 Rev. E
2010 Commercial Wireless Systems International, LLC
2
Figure 1 Proper Mounting to Ceiling Tile
Tamper-Resistant Feature
The smoke detector includes a tamper-resistant feature that prevents removal from the
mounting base without the use of a tool. To engage the tamper-resistant feature, cut the
small plastic tab located on the mounting base (Figure 2), and then install the detector. To
remove the detector from the base once it has been made tamper resistant, insert a small
screwdriver in the hole located near the alignment mark, and turn the detector
counterclockwise.
Figure 2 Tamper Resistant Feature
Cautions:
1. Make sure the batteries are firmly installed in the smoke detector battery holders.
2. The unit must be secured tightly to the wall, so as to not be dislodged.
3. Test the unit after any service, changing the batteries or as often as local or national
codes dictate.
Do NOT Install Detectors in the Following Areas:
•
In or near areas where particles of combustion are normally present such as
kitchens; in garages; near furnaces, hot water heaters, or gas space heaters.
kitchens; in garages; near furnaces, hot water heaters, or gas space heaters.
•
In very cold or very hot areas.
•
In wet or excessively humid areas, or next to bathrooms with showers.
•
In dusty, dirty, or insect-infested areas.
•
Near fresh air inlets or returns or excessively drafty areas.