Accton Wireless Broadband Corp. FIU176205000W User Manual

Routing

5-41

• Add Enrollee PIN Code – In Registrar mode enter the PIN Code for the WDS 

device that wants to join the network.

• PIN Code of this AP – In Enrollee mode this displays the PIN Code for the wireless 

AP/Router. The default is exclusive for each unit.

• Start WPS Config – Sends a handshake beacon to devices wanting to join the 

network, for a duration of two minutes.

Routing setup allows a manual method that is used to set up routing between 
networks. The network administrator configures static routes in a router by entering 
routes directly into the routing table of a router. Static routing has the advantage of 
being predictable and easy to configure. 

This screen is used to manually configure static routes to other IP networks, 
subnetworks, or hosts. Click "Network Settings" followed by “Static Route." 
(Maximum 32 entries are allowed.)

• Enable – Enables the configured route. (Default: Disabled)
• Target – A destination network or specific host to which packets can be routed.
• Netmask – The subnetwork associated with the destination. This is a template that 

identifies the address bits in the destination address used for routing to specific 
subnets. Each bit that corresponds to a “1” is part of the network/subnet number; 
each bit that corresponds to “0” is part of the host number.

• Gateway – The IP address of the router at the next hop to which matching frames 

are forwarded.

• Action – Specifies an action to take on a static route.

- Change: By selecting a configured route from the routing table its parameters 

display in an editable form. Click “Change” to save parameters once you have 
updated them.

- Add: Adds a newly configured route to the list.