Accton Wireless Broadband Corp. FIU176205T01W User Manual

Page of 112
–  5  –
C
OMPLIANCES
F
EDERAL
 C
OMMUNICATION
 C
OMMISSION
 I
NTERFERENCE
 S
TATEMENT
This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits 
are designed to provide reasonable protection against harmful interference 
in a residential installation. This equipment generates, uses and can 
radiate radio frequency energy and, if not installed and used in accordance 
with the instructions, may cause harmful interference to radio 
communications. This transmitter must not be co-located or operating in 
conjunction with any other antenna or transmitter. However, there is no 
guarantee that interference will not occur in a particular installation. If this 
equipment does cause harmful interference to radio or television reception, 
which can be determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one of the following 
measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC Rules. Operation is subject to 
the following two conditions: (1) This device may not cause harmful 
interference, and (2) this device must accept any interference received, 
including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the 
party responsible for compliance could void the user's authority to operate 
this equipment. 
IEEE 802.11b or 802.11g operation of this product in the U.S.A. is 
firmware-limited to channels 1 through 11.
IMPORTANT NOTE:
FCC R
ADIATION
 E
XPOSURE
 S
TATEMENT
This equipment complies with FCC radiation exposure limits set forth for an 
uncontrolled environment. This equipment should be installed and 
operated with minimum distance 20 cm between the radiator and your 
body.