Sony NSBKA16 Leaflet
4
Pull the protection cover upward and remove it.
r
Rear panel side
5
Insert the analog encoder board with the proper orientation.
6
Install the analog encoder board.
Make a visual check at the following two points and confirm that the board is firmly connected.
Make a visual check at the following two points and confirm that the board is firmly connected.
Make a visual check.
Caution
Incomplete and/or skewed insertion of the board can cause improper connection.
Incomplete and/or skewed insertion of the board can cause improper connection.
7
Reattach the top cover by reversing removal procedures 1 and 2.
English
About This Document
This manual is intended for qualified service personnel only.
Trademarks
• “IPELA” and
are trademarks of Sony Corporation.
• Other products or system names appearing in this document are trademarks or registered trademarks of
their respective owners.
Further, the ® or ™ symbols are not used in the text.
Precautions
To the technician installing the unit
• Please refer to the Installation Manual supplied with the NSR-1200/1100 and NSBK-A16 for
• Please refer to the Installation Manual supplied with the NSR-1200/1100 and NSBK-A16 for
installation instructions.
• Before installing the unit, be sure to unplug the NSR-1200/1100 and wait until the internal temperature
drops.
Before Use
This document describes how to install the Analog Encoder Kit NSBK-A16 in the Sony Network
Surveillance Server NSR.
Surveillance Server NSR.
Applicable Models/Versions
NSR-1100
All Versions
NSR-1200
All Versions
Setup Flowchart
1
Installing the analog encoder board on the NSR (refer to Step 1 in this manual.)
m
2
Connecting the analog camera input cable (refer to the NSBK-A16 Installation Manuals.)
m
3
Connecting analog cameras (refer to the NSR-1200/1100 and NSBK-A16 Installation Manuals.)
m
4
Verifying operation (refer to the NSR-1200/1100 Installation Manuals.)
m
End.
Procedures
Caution
• Perform installation work in an antistatic environment.
• Before installing the analog encoder board, be sure to turn off and unplug the NSR and wait until the
• Perform installation work in an antistatic environment.
• Before installing the analog encoder board, be sure to turn off and unplug the NSR and wait until the
internal temperature drops.
Step 1 Installing the analog encoder board on the NSR
1
Remove the three screws shown below.
Tightening torque when installing: 6 kgf·cm
Tightening torque when installing: 6 kgf·cm
2
Slide the top cover in the direction of the arrow to remove it.
3
Confirm the installation position.
r
Rear panel side
Install the analog encoder
board here.
board here.
Rear panel side
T
Protection cover
Analog encoder board